STM32 Nucleo

STM32 Nucleo F767ZI demo board can be used with LogicLab Automation Suite.

All informations about Nucleo F767ZI target board and ST software are available on STMicroelectronics website [1]

How to start

1) Download Axel Automation Suite

2) Install Axel Automation Suite

3) Start LogicLab and create new Nucleo project

4) From the main target page open user manual

5) See user manual chapter 3 - Firmware Upgrade to configure Nucleo target board with Axel Nucleo firmware

6) See user manual chapter 1 - Quickstart to connect to target device via USB-Serial or Ehernet

7) Once connected to target, enter product key provided by Axel in main target page

8) Nucleo is now ready for LogicLab

User plugins and firmware development

Nucleo firmware source can be provided by Axel only by explicit request.

If request is accepted Axel will provide firmware sources and guidelines for development.

Nucleo firmware has been developed using STM32CubeIDE.

See Nucleo versions for the STM32CubeIDE version used for development.

Nucleo versions

Nucleo F767ZI 3p0

• PLC
• SoftScope
• Database
• Local I/O (plugin sample)
• Modbus RTU master
• Modbus RTU slave
• CANopen master
• Modbus TCP master (new)
• Modbus TCP slave
• Symbols server (new)
• Network scan support
• Plugin API for custom plugins development
• Plugin builder (new)

Firmware developed and tested with STM32CubeIDE 1.5.1

Nucleo F767ZI 2p0

• PLC
• SoftScope (new)
• Database
• Local I/O (plugin sample)
• Modbus RTU master
• Modbus RTU slave
• CANopen master
• Modbus TCP slave (new)
• Network scan support (new)
• Plugin API for custom plugins development (new)

Quickstart and documentation Nucleo_F767ZI_2p0.pdf

Firmware developed and tested with STM32CubeIDE 1.3.0

Nucleo F767ZI 1p0

• PLC
• Database
• Local I/O
• Modbus RTU master
• Modbus RTU slave
• CANopen master
• Modbus TCP slave

Quickstart and documentation Nucleo_F767ZI_1p0.pdf

Firmware developed and tested with STM32CubeIDE 1.3.0

Nucleo firmware note

Based on Nucleo 3p0 firwmare

Plugin/sw component                             Flash size  RAM size    Notes 
AlPlcRuntimeCoreLib
PLC code                                            KB                  Reserved area to run PLC application code
PLC data                                                        KB      Reserved area for PLC application variables
Database
SoftScope
Database
Local I/O                                           KB                  Basic I/O plugin
Modbus RTU master + slave                        17 KB      65 KB+(*)   Modbus RTU master is configured to manage up to 32 slaves
CANopen master                                   18 KB       2 KB+(*)   CANopen master can manage up to 126 slaves
Modbus TCP master                                18 KB      26 KB+(*)   Modbus TCP master is configured to manage up to 16 slaves.
Modbus TCP slave
Symbols server                                      KB      (*)
Network scan

(*) some resources, depending on user configuration, are allocated into PLC data area when plugin configuration code is generated.