STM32 Nucleo: Difference between revisions
Jump to navigation
Jump to search
Line 17: | Line 17: | ||
* Click ''Ok'' | * Click ''Ok'' | ||
* Now from the main menu bar, choose ''On-line'' -> ''Connect'' | * Now from the main menu bar, choose ''On-line'' -> ''Connect'' | ||
* Now, in the right-lower corner of the application window, you should see a green rectangle with the word | * Now, in the right-lower corner of the application window, you should see a green rectangle with the word ''CONNECTED'' written inside. | ||
=== Ethernet connection === | === Ethernet connection === |
Revision as of 16:26, 30 November 2020
We're sorry, this page is under construction
This guide is intended for STM32 Nucleo F767ZI demo board, with Axel runtime.
Quickstart
USB connection
It is possible to connect the Nucleo board via USB-Serial connection; just refer to the following steps:
- Connect USB cable into CN1 connector.
- Open LogicLab.
- Create new Nucleo_F767ZI project.
- Select from LogicLab main menu bar On-line -> Set up communication.
- Select Modbus protocol, click on Activate button and then on Properties button, the settings dialog will appear; configure it as shown in the image below:
- Click Ok
- Now from the main menu bar, choose On-line -> Connect
- Now, in the right-lower corner of the application window, you should see a green rectangle with the word CONNECTED written inside.