LLExec for RTX (32bit) usage instructions

Prerequisites

RTX must be alredy correctly installed and configured on the Windows system
RTX must have the virtual network interface (between RTX and Windows) correctly configured
RTX must have one physical network interface correctly assigned and configured (for EtherCAT master only)

Get the latest version of LogicLab Automation suite setup from Axel website (public download area)
Get the latest version of LLExec (x86 Windows) setup from Axel website (public download area)
Get the latest version of LLExec for RTX binaries from Axel website (private customer area)
Get the latest version of socat binaries from Axel website (private customer area)

Install the LogicLab Automation suite using the setup
Install the LLExec (x86 Windows) using the setup
Unzip the LLExec archive where you want
If you DO NOT NEED EtherCAT master functionality:
- edit RegisterRtxDll.bat and remove the registration of LLXPlugin_EtherCAT_RTX.rtdll and RTXFilterDriver.rtdll
- edit LLExec_RTX.conf and remove the line with LLXPlugin_EtherCAT_RTX.rtdll
Execute RegisterRtxDll.bat to register the .rtdll components in the system
Get the latest version of socat binaries from Axel website
Unzip the socat archive where you want
If the IP address of the RTX side of the virtual network interface is different from 192.168.1.1, please edit the socat_LLExec.bat

Execute LLExec_RTX.bat to launch LLExec
- On the first execution, LLExec will save a HardwareID.txt file on the disk and quit immediately; please send this file to support@axelsw.it and you will receive back a license file named LLExecRTX.key, to be placed in the same folder
Execute socat_LLExec.bat to allow LogicLab connections from the LAN

Execute LogicLab
Create a new project using the LLExec PLC runtime (RTX) target
Configure the GDB connection using the normal IP address of the Windows side, port 5000